How To Apply Car Decals Wet

To clamp the halves together and then to run glue on the outside of the joint would spell disaster.

How to apply car decals wet. The wet method involves making a soap solution using a mixture of dish soap and water to get both the application surface and the adhesive side of the decal wet before applying the decal. Cut the first decal from the sheet. (you could use an i.d.

Move slowly, sealing the vinyl to the car little by little. After the entire transfer tape and decal has been applied onto the surface, rub thoroughly and evenly the entire surface of the transfer tape with a few more firm strokes. This should help the decal adhere to the surface of the vehicle better, and it also allows you to slide the decal.

Contingent on your wrapping experience, abilities and the kind of vinyl you are applying to your car, wet or dry applications may suit your situation better than the other. Generally speaking, the steps to install a decal are clean the application surface, remove decal backing, apply application solution (if there is one), position decal in the desired location, press firmly and use a squeegee to get rid of air bubbles. Use a credit card or squeegee to smooth the decal onto the surface.

4) spray window cleaner on the exposed adhesive surface of the. Trim or fold back the separated backing. Do not worry if your decal seems a little slippery.

Keeping this in mind, read below to learn how to install car window decals in 2 ways. During this step do not get the backing paper wet, it will ruin your decal. Using the tape markings as your guide, place one edge of the vinyl decal on the vehicle and begin to smooth it out with a straight edge, such as a paint scraper or credit card.

Upon immersion with water, the decal literally slides off the backing paper, allowing you to apply it to the surface of your scale model with relative ease. You will then place your wet decal onto your desired surface. Begin by spraying the surface with the wetting solution.